AT-HDVS-210H-TX-WP-KIT Firmware

Firmware AT-HDVS-210H-TX-WP Firmware Version 1.0.38
File Size 902 KB
Date 12.04.19
Version 1.0.38

Features

  • Added display control support when connected to the AT-UHD-CLSO-824.

Bug Fixes

  • The front-panel LED indicators now flash the correct number of times to properly indicate the selected IP mode.
  • Fixed an issue where, when connected to the AT-HDVS-200-RX, display control commands would not be passed to the display.
  • Fixed an issue where, when connected to the AT-OME-RX21, display control programming is now performed from the AT-OME-RX21.
Previous Releases
Version 1.0.21

Features

  • Added support for hostname identification.
  • Added help tips on EDID and Display Web UI pages.

Bug Fixes

  • Resolved an issue where credentials were incorrectly being validated on the login page.
  • Resolved an issue with RS232 zone settings not being retained after a loss of power.
  • Resolved an issue where the default IP address in the Display page of the Web UI would default to 255.255.255.0.
  • Resolved an issue where using the “sta” argument with the “System” command would return an invalid MAC address.
Version 1.0.21
  • Compatibility update for AT-HDVS-200-RX, AT-UHD-CLSO-612ED, and AT-HDVS-SC-RX.
Version 1.0.17

Bug Fixes

  • Update to the built-in web interface.
  • Improved Telnet login handling when invalid credentials are provided.
Version 1.0.13

Bug Fixes

  • Fixed an issue where the serial baud rate of 56000 was invalid.
  • Fixed an issue where performing a factory reset, using the button under the faceplate, the serial baud rate was not set to the default setting of 115200.
  • Improved reporting on Video Info page, in the webGUI.
  • Improved system stability.
Version 1.0.10

Features

  • Added new commands:
    • InputStatus – This command provides the current status of the HDMI inputs. Return values are: 0 = no source present, 1 = source present. The status of an individual input can be returned by using the input number as an argument.
    • InputBroadcast – Enabling this feature, using the on argument, will return the input status on all HDMI inputs. The default setting is on.
  • Added General tab which reports the following devices: AT-HDVS-200-RX, AT-UHD-SW-5000ED, AT-UHD-CLSO-612ED, and AT-UHD-CLSO-824.

Bug Fixes

  • Fixed an issue where the VIC in the EDID video data block was repeated for EDID 12 (3840×2160@30 2CH) and EDID 13 (3840×2160@30 MCH).
  • Resolved an issue where the Samsung K8500 source would not pass the A/V signal when connected to a 6G display.
  • Fixed an issue where if a PC monitor (e.g. ASUS PB287Q) was placed in sleep mode, when connected to an HDCP source through an extender kit, would diminish the A/V signal at the sink device.
  • Fixed an issue where auto-switching did not function correctly when quickly disconnecting and reconnecting an input.
Version 1
  • Factory firmware
Version x.31.31.5

Features

  • Added CRC validity check of firmware images.

Bug Fixes

  • Resolved an issue where video was dropping, momentarily, following a disconnect-reconnect of the source device.
  • Fixed an issue with 720p60 10bpc, using Quantum Data pixel error test results.
  • Improved HDMI performance at low pixel clock speeds (< 100 MHz ).
  • Improved HDMI error filtering.