Changed the default output resolution from 720p60 to Native. NOTE: Firmware 1.0.7 is to be used with the AT-HDVS-150-RX running version 1.0.7 (hardware Rev D or lower) or version 2.0.01 (hardware Rev E or higher).
Fixed an issue where the Auto Off (sec) timer was not configurable using the OSD menu system.
Fixed an issue where Audio settings were not saved after the receiver loses power.
Fixed an issue where power-cycling the unit causes the receiver to send a reboot command, over RS-232, regardless of the system state.
Unit no longer locks up when receiving an unrecognized resolution.
Resolved issue where the unit sends a power command when it is power cycled